Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Intrusion switch
- Front bezel
- Hard-drive assembly
- Hard-drive and optical-drive module
- Optical drive
- Solid-state drive
- WLAN card
- SD card reader - optional
- Expansion card
- Memory modules
- Heat sink
- Coin-cell battery
- Processor
- Power switch
- Power-supply unit
- System fan
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
SD card reader - optional
Removing the SD card reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the Side cover
3. Remove the Front bezel
4. Remove the Hard drive assembly
5. Remove the Optical drive assembly
About this task
The following images indicate the location of the graphics card and provide a visual representation of the removal procedure.
Steps
1. Unroute the power supply cables from the retention clip on the SD card reader.
2. Remove the two screws (M6X32) and lift the SD card reader from the chassis.
Installing the SD card reader
Prerequisites
About this task
The following image indicates the location of the SD card reader and provides a visual representation of the installation
procedure.
30
Disassembly and reassembly