Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Intrusion switch
- Front bezel
- Hard-drive assembly
- Hard-drive and optical-drive module
- Optical drive
- Solid-state drive
- WLAN card
- SD card reader - optional
- Expansion card
- Memory modules
- Heat sink
- Coin-cell battery
- Processor
- Power switch
- Power-supply unit
- System fan
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Place the side cover on your computer.
2. Slide the side cover towards the front of the system till you hear the release latch click.
Next steps
1. Follow the procedure in after working inside your computer.
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the Side cover
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Slide the intrusion switch from the system .
Installing the intrusion switch
Prerequisites
Disassembly and reassembly
11