Owners Manual
Table Of Contents
- Precision 3240 Compact Service Manual
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw List
- SMA antenna
- Side cover
- Top Cover
- Front bezel
- Hard-drive assembly
- WLAN card
- Speaker
- Fan assembly
- Memory modules
- Riser card
- Dell Ultra Speed Drive
- Graphics card
- Solid-state drive
- Optional IO card
- Coin-cell battery
- Heat sink
- Interposer module
- Processor
- System board
- Internal antenna
- System board
- Internal antenna
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
1. Install the fan assembly.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Riser card
Removing the riser card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
About this task
The following images indicate the location of the riser card and provide a visual representation of the removal procedure.
Disassembly and reassembly
43