Owners Manual

Installing System Components 115

RAID Battery (Optional)

Removing the RAID Battery

CAUTION: Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in

your product documentation, or as directed by the online or telephone service

and support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came

with the product.

NOTE: The information in this section applies only to systems with the optional

RAID controller card.

Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

Open the system. See "Opening the System" on page 66.

To disconnect the RAID battery cable by gently pulling the cable

connector out of the connector. See Figure 3-22.

Pull back gently on the two tabs holding the RAID battery and lift the

RAID battery from the battery carrier. See Figure 3-22.

Figure 3-22. Removing and Installing the RAID Battery

1 battery carrier 2 battery cable connector

3 RAID battery 4 battery carrier tabs (2)