Setup Guide

10 Dell PowerVault ML6000 Getting Started Guide
Connecting Fibre Channel Cables to a Host or
Switch
Perform this step if your library contains Fibre Channel tape drives that you will be
connecting directly to a host or switch.
Use Fibre Channel cables to connect your host (or switch) to the library. For each
tape drive:
1 Connect one end of the Fibre Channel cable to the Fibre Channel port on the
tape drive.
2 Connect the other end of the Fibre Channel cable to your host or switch.
1 Fibre Channel port 2 Fibre Channel cable
EMEA2.book Page 10 Thursday, September 3, 2015 3:45 PM