Owners Manual
Table Of Contents
- Dell EMC PowerVault MD3460 Storage Arrays Owner's Manual
- About your system
- Controller modules
- Installing and removing system components
- Troubleshooting your system
- Troubleshooting storage array startup failure
- Troubleshooting loss of communication
- Troubleshooting external connections
- Troubleshooting power supply modules
- Troubleshooting array cooling problems
- Troubleshooting expansion enclosure management modules
- Troubleshooting physical disks
- Troubleshooting array and expansion enclosure connections
- Troubleshooting a wet storage array
- Troubleshooting a damaged array
- Controller failure conditions
- Technical specifications
- Getting help
Table 11. Back-panel connectors (per raid controller module) (continued)
Table 12. Power
AC power supply (per power supply)
Wattage 1755 W
Heat dissipation (maximum)
NOTE: Heat dissipation is calculated using the
power supply wattage rating. The heat dissipation
values are for the entire system which includes
chassis and two controllers.
5988 BTU/hr
Voltage
NOTE: This system is also designed to be
connected to IT power systems with a phase to
phase voltage not exceeding 230 V.
220 V AC, autoranging, 50 Hz/60 Hz
Battery 6.6 V DC, 1100 mAh, 7.26 W Lithium ion battery
Table 13. Environmental
NOTE: For additional information about environmental measurements for specific system configurations, see dell.com/
environmental_datasheets.
Temperature
Operating Continuous operation: 10 °C to 35 °C (50 °F to 95 °F) at 20% to
80% relative humidity (RH), with 26 °C maximum dew point. De-
rate maximum allowable dry bulb temperature at 1 °C/300 m (1 °F
per 550 ft) above 900 m (2952.75 ft).
NOTE: For information on supported expanded operating
temperature range and configurations, see the Owner's Manual
at dell.com/support/manuals.
Storage –40 °C to 65 °C (–40 °F to 149 °F) with a maximum temperature
gradation of 20 °C per hour
Relative humidity
Operating 20% to 80% (noncondensing) with maximum humidity gradation of
10% per hour
Storage 5% to 95% at a maximum wet bulb temperature of 38 °C (100.4
°F)
Maximum vibration
Operating 0.26 G
rms
at 5 Hz to 350 Hz in operational orientation
Storage 1.88 G
rms
at 10 Hz to 500 Hz for 15 minutes (all six sides tested)
Maximum shock
Operating
One shock pulse in the positive z axis of the system at 31 G for 2.6
ms in the operational orientation
Storage Six consecutively executed shock pulses in the positive and
negative x, y, and z axes (one pulse on each side of the system) at
71 G for up to 2 ms
Six consecutively executed shock pulses in the positive and
negative x, y, and z axes (one pulse on each side of the system) of
22 G faired square wave pulse with velocity change at 200 inches/
second (508 centimeters/second)
Altitude
40 Technical specifications