Owners Manual
Table Of Contents
- Dell EMC PowerVault MD3460 Storage Arrays Owner's Manual
- About your system
- Controller modules
- Installing and removing system components
- Troubleshooting your system
- Troubleshooting storage array startup failure
- Troubleshooting loss of communication
- Troubleshooting external connections
- Troubleshooting power supply modules
- Troubleshooting array cooling problems
- Troubleshooting expansion enclosure management modules
- Troubleshooting physical disks
- Troubleshooting array and expansion enclosure connections
- Troubleshooting a wet storage array
- Troubleshooting a damaged array
- Controller failure conditions
- Technical specifications
- Getting help
Installing and removing system components
Topics:
• Recommended tools
• Removing and installing the front bezel
• Service action allowed indicator LED
• SAS chain cables
• Physical-disk drawers
• Physical disks
• RAID controller modules
• RAID controller module backup battery unit
• Power supplies
• Cooling fan modules
Recommended tools
You may need the following items to perform the procedures in this section:
● #2 Phillips screwdriver
● T8 and T15 Torx screwdrivers
● Wrist grounding strap connected to ground
Removing and installing the front bezel
Installing the front bezel
You must install the front bezel on the system to secure the disk drawers against accidental removal.
1. Align the slots on the back of the bezel with the guide pins on the front of the chassis.
2. Push the bezel toward the chassis until the bezel is seated properly and the release latches snap into place.
3
16 Installing and removing system components