Deployment Guide

2. The default name for a newly installed PowerVault MD3460 series storage array is Unnamed. If another name is displayed in MD
Storage Manager, click the down arrow next to the name and click Unnamed in the drop-down list and rename the array.
3. Double-click on the discovered array to launch the array management window and make changes to the configuration of the array.
4. Click Perform Initial Setup Tasks to see an outline and links to the remaining post-installation tasks.
The array is now ready to be configured. See the Administrator's Guide at dell.com/powervaultmanuals for information about each
task and to perform the necessary configuration steps. The following table lists the recommended configuration steps that can be
accomplished in MD Storage Manager.
NOTE: Before configuring the storage array, check the status icons on the Device pane to ensure that the enclosures
in the storage array are in an Optimal status. For more information on the status icons, see the Owner’s Manual at
dell.com/powervaultmanuals.
Table 1. Initial Setup Tasks
Task Purpose
Rename the
storage array
To provide a more meaningful name than the software-assigned
label, Unnamed.
Set a storage
array password
To restrict unauthorized access. MD Storage Manager may ask for a
password before changing the configuration or performing a
destructive operation.
Set up alert
notifications
Set up e-mail
alerts
Set up SNMP
alerts
To notify individuals (by e-mail) and/or storage enterprise
management consoles, such as Dell Management Console, (by
SNMP) when a storage array component degrades or fails, or an
adverse environmental condition occurs.
Configure a
storage array
To create virtual disks and map them to hosts.
Post Installation Tasks 21