Reference Guide

Script Commands 165
Parameters
NOTE: A file extension is not automatically appended to the saved file. You must
specify the applicable format suffix for the file. If you specify a file extension of .txt,
then the output will be in a text file format. If you specify a file extension of .xml,
then the output will be in an XML file format.
Save Physical Disk Log
This command saves the log sense data to a file. Log sense data is maintained
by the storage array for each physical disk.
Syntax
save allPhysicalDisks logFile=" filename "
Parameters
Save RAID Controller Module NVSRAM
This command saves a copy of the RAID controller module NVSRAM values
to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file=" filename "
Parameter Description
file The name of the file in which you are storing the results of
the fault isolation diagnostics test on the drive channel.
Enclose the name in double quotation marks (" ").
Parameter Description
logFile Name of the file to which to write the log sense data. You
must put quotation marks (" ") around the file name.