Deployment Guide

Preparing Your Systems for Clustering 45
Ipv6 addresses (Default IP addresses):
Controller 0, Port 0: IP Configuration: Obtain configuration automatically
Port: 3260
Controller 0, Port 1: IP Configuration: Obtain configuration automatically
Port: 3260
Controller 1, Port 0: IP Configuration: Obtain configuration automatically
Port: 3260
Controller 1, Port 1: IP Configuration: Obtain configuration automatically
Port: 3260
NOTE: By default, the gateway value is not set.
To configure the iSCSI ports on the storage array, complete the following
steps:
1
From MD Storage Manager, click iSCSI and select Configure iSCSI
Host Ports
.
2 Configure the iSCSI ports on the storage array.
NOTE: Using static IP addressing is recommended, although DHCP is
supported.
Setting Static IP addresses:
Ipv4 Configurations – Only one IP address can be configured per controller
per port.
Ipv6 Configurations – Two routable IP addresses can also be configured in
addition to one Link-local IP address assigned to each port of both the
controllers.
The typical format used for the IP addresses is as below:
Link Local IP address:
FE80:0000:0000:0000:XXXX:XXXX:XXXX:XXXX
Routable IP address 1:
XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX
Routable IP address 2:
XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX
book.book Page 45 Tuesday, April 15, 2008 12:30 PM