Dell PowerVault MD Storage Arrays Management Pack Suite Version 4.
The Release Notes provide information on the Dell MD Storage Arrays Management Pack Suite version 4.1, which can be imported into Microsoft System Center Operations Manager (SCOM) 2007 SP1/R2 and System Center Essentials (SCE) 2007 SP1/2010. NOTE: All references to Operations Manager are also applicable to System Center Essentials. The Dell MD Storage Arrays Management Pack Suite v4.1 enables SCOM to discover and monitor the status of Dell PowerVault MD Storage Arrays, on a defined network segment.
• • Minimum disk space of 5 GB, for SCOM to run the Array Bridge Broker (ABB) executable file. Modular Disk Storage Manager (MDSM) is required to diagnose and resolve recovery failure alerts. Installation and Configuration Notes This section provides information about the minimum requirements for installing and using the Dell MD Storage Arrays Management Pack Suite version 4.1 for Microsoft System Center Operations Manager SP1/R2 and System Center Essentials 2007 SP1/2010.
• MD1220 when daisy chained to MD3200/MD3200i/MD3220/MD3220i/MD3600i/ MD3620i/MD3600f/MD3620f Upgrade You can upgrade Dell MD Storage Arrays Management Pack Suite 4.0 to Dell MD Storage Arrays Management Pack Suite 4.1. For information on upgrading the Dell MD Storage Arrays Management Pack Suite version 4.1 for Microsoft SCOM 2007 SP1/R2 and SCE 2007 SP1/2010, refer the "Dell PowerVault MD Storage Arrays Management Pack Suite Version 4.
Issue 2: The tooltip for objects in the Diagram view of the SCOM Web console does not display any information related to attributes. Description The tooltip shown on selecting the MD storage Array device objects in the Diagram view of the SCOM Web console does not display any information related to attributes. Resolution No known resolution. This is a limitation in the SCOM 2007 R2 Web console and SCOM 2007 SP1 Web console. Versions Affected SCOM 2007 R2 Web console and SCOM 2007 SP1 Web console.
Issue 5 - DF345485: The SCOM 2007 SP1 Web console displays only 15 objects in its Diagram view. Description When there are more than 15 objects in a group, the SCOM 2007 SP1 Web console displays only 15 objects. Resolution No known resolution. This is a limitation in the SCOM 2007 SP1 Web console. Versions Affected SCOM 2007 SP1 Web console. Issue 6 - DF357269: Removing an IP address from the MD Array IP configuration file, should remove the corresponding alerts for that device in SCOM console.
Issue 8 - DF325583: The description under the Management Pack Properties tab contains unknown characters as separators Resolution No known resolution. Versions Affected Microsoft System Center Operations Manager (SCOM) 2007 SP1, System Center Essentials (SCE) 2007 SP1. Issue 9 - DF495470: When upgrading to 4.1, MD Storage Arrays may disappear from the MD Storage Array Diagram and State View for few minutes.
Issue 12 - DF 492918: Fan position for daisy chained enclosure (MD1000) maybe shown incorrectly when daisy chained to MD3000. Resolution You need to launch the Modular Storage Disk Manager (MDSM) to find the actual position of the fan for MD1000. Versions Affected Microsoft System Center Operations Manager (SCOM) 2007 SP1/R2, System Center Essentials (SCE) 2007 SP1/2010, Dell PowerVault MD Storage Arrays Management Pack Suite v4.0/4.
Global Support For information on technical support, visit dell.com/contactus. For information on documentation support, visit support.dell.com/manuals. On the Manuals page, click Software -> Systems Management. Click on the right-side, and select the product to access the documents. Information in this document is subject to change without notice. © 2011 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.
