Owner's Manual

Dell MD Storage Arrays Management Pack Suite Operations 21
7 Click Apply .
8 Similarly select Dell MD Storage Array Discovery under the MD Storage
Array Seed Discovery group
object and repeat step 4 to step 7 in order to
override its discovery interval.
NOTE: When you upgrade the MD Storage Arrays Management Pack from version
4.0 to 4.1, discovery interval overrides specified in version 4.0 are carried over only
to the Seed Discovery interval.
NOTE: Override the Dell MD Storage Array Discovery interval setting to the same
interval seconds specified in the Seed Discovery interval in order to run both the
discovery cycles at the same schedule.
Unit Monitors
You can customize the following parameters of the MD Storage Arrays
Management Pack unit monitors by using overrides:
• Enabled : Allows you to enable or disable monitors. You can choose the
Override Setting to be True or False. The default setting is True.
• Interval in Seconds : The frequency (in seconds) with which the
Management Pack polls the Dell device to check the health of a
component. The default setting for monitors could range between 3600 -
4300 seconds.
NOTE: When you upgrade the MD Storage Arrays Management Pack from version
4.0 to 4.1, unit monitor override settings specified in version 4.0 are not carried over
to version 4.1 and do not work.
To specify override parameters for unit monitors:
1
Launch the SCOM console and click the Authoring tab.
2 Select Monitors under Management Pack Objects in the Authoring pane.
3 Select the component unit monitor, right-click and select Overrides 
Override the Monitor . You can choose to override objects of a specific type
or for all objects within a group
.
4 Check on the appropriate monitor parameter that you want to override
and set its
Override Value .
A5_bk0.book Page 21 Tuesday, September 20, 2011 11:56 AM