Users Guide

Table 13. Default library configuration settings (continued)
Configuration Item Default Setting
Time zone (GMT) +00:00
Date (MM/DD/YYYY) 01/08/2008
Auto adjustment by PC Every 1 minute
NOTIFICATIONS
SMTP (mail) settings
Mail server address 0.0.0.0
Mail event Error events enabled
SNMP (trap) settings
Community Public
Trap event Error events enabled
SNMPv3 engine ID (Set by library firmware)
Static library network settings must be entered with the Operator Panel before the library can be accessed
remotely with the Web User Interface. If your system is serviced by a Dynamic Host Configuration
Protocol (DHCP) server, the network parameters are automatically set. Once remote access is established,
you can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to “Configuring your library with
the Operator Panel” on page 47.
Configuring your library with the Web User Interface
If you choose to use the Web User Interface to configure your library, first enter your library network
settings with the Operator Panel (see “Configuring network settings” on page 63).
To configure your library with the Web User Interface:
1. “Logging in to the Web User Interface”
2. “Checking firmware level” on page 33
3. “Configuring library settings” on page 34
4. “Configuring network settings” on page 35
5. “Configuring date and time settings” on page 37
6. “Configuring encryption settings” on page 38
7. “Configuring email notifications” on page 40
8. “Configuring trap notifications” on page 41
9. “Managing user access” on page 43
10. “Saving the library configuration” on page 46
Logging in to the Web User Interface
To log in to the Web User Interface:
1. If necessary, obtain the IP address of the library on the Operator Panel.
a. From the top menu of the Operator Panel, press the Minus key to select View Current
Information, and press Enter.
b. Press the Minus key until the IP Address setting is displayed and make a note of the IP address.
c. Press the Cancel key repeatedly to log out of the Operator Panel.
2. Open Internet Explorer on your server or PC to access the Web User Interface.
32 Dell PowerVault TL1000 Tape Autoloader: User's Guide