Users Guide

Installation and configuration
“Choosing a location”
“Acclimation” on page 22
“Installing in a rack” on page 22
“Removing the accessor locking screw” on page 28
“Attaching the library to a server” on page 29
“Configuring your library with the Web User
Interface” on page 32
“Logging in to the Web User Interface” on page 32
“Checking firmware level” on page 33
“Configuring library settings” on page 34
“Configuring network settings” on page 35
“Configuring date and time settings” on page 37
“Configuring encryption settings” on page 38
“Configuring email notifications” on page 40
“Configuring trap notifications” on page 41
“Managing user access” on page 43
“Saving the library configuration” on page 46
“Configuring your library with the Operator
Panel” on page 47
“Logging in to the Operator Panel” on page 47
“Configuring network settings” on page 47
“Configuring library settings” on page 48
“Populating the library with cartridges” on page 49
“Verifying library and drive operation” on page 51
“Taking the library online” on page 51
“Registering for support notification” on page 52
To install and configure a TL1000 Tape Autoloader, complete these procedures in the order they are
presented.
Choosing a location
Table 12. Location criteria
Criteria Definition
Room temperature 16 - 32 °C (60 - 90 °F)
Voltage 100 - 240 Vac. (4.0 to 1.5 A)
Note: The power switch is on the rear of the library and
must be easily accessible.
Frequency 50 - 60 Hz
Relative humidity 20 - 80% non-condensing
21