White Papers
Table Of Contents
- Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target
- A Dell Technical White Paper
- by
- Dell Engineering
- Revision 1.0
- Executive Summary
- Introduction
- Prerequisites
- Technical Resources
- Configuration and Settings
- Installing the Dell PowerVault MD3000i Storage Software on the DL Backup to Disk Appliance
- Figure 2: MD3000i Resource CD menu
- Exposing the PowerVault™ MD3000i virtual disks to the DL Backup to Disk Appliance
- Configuring the PowerVault™ DL Backup to Disk Appliance Array Access
- Figure 4: MD3000i iSCSI Initiator Target portals
- Figure 6: CHAP logon information
- Conclusions
Configuring the Dell™ PowerVault™ MD3000i Array as a Backup Target for CommVault™ Simpana™
Page 9
Figure 5: Logging on to the MD3000i Targets
5. If the virtual disk requires CHAP credentials, click Advanced in the Log On to Target dialog
box. Set the CHAP logon information check box and specify the CHAP user name and secret.
(Refer to figure 6) (For more information on how to setup/configure MPIO, please refer to the
“MPIO to PowerVault™ MD3000i Array with MICROSOFT iSCSI INITIATOR” under technical
resources section)