Storage System Hardware Owner's Manual
Table Of Contents
- Hardware Owner’s Manual
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel
- Opening and Closing the System
- Hard Drives
- Replacing a Hard-Drive Carrier
- Power Supplies
- System Fans
- Cooling Shroud
- Fan Brackets
- Cable Routing
- SAS Controller Daughter Card
- Configuring the Boot Device
- Expansion Cards
- Expansion-Card Cage
- DRAC Card and Cables
- Optical Drive and Cable
- System Memory
- Activating the Integrated NIC TOE
- Processors
- System Battery
- Expansion-Card Riser Boards
- Sideplane Board
- SAS Backplane Board
- Control Panel Assembly (Service-only Procedure)
- System Board (Service-only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Basic I/O Functions
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller Daughter Card
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index
94 Installing System Components
5
Angle the DRAC card so that its NIC connector inserts through the back-
panel DRAC card opening, aligning the card with the back standoff.
Figure 3-16. Installing and Removing a DRAC Card
6
Align the front edge of the DRAC card with the two front plastic retention
standoffs adjacent to the DRAC system board connector, and press down
the side of the card until it is fully seated. See Figure 3-16.
When the front of the card is fully seated, the front plastic standoffs snap
over the front edge of the card.
1 DRAC-card connectors (2) 2 DRAC-card cables (2)
3 retention standoff hole 4 DRAC card
5 filler plug 6 support standoffs holes(2)
4
6
5
3
1
2
Book.book Page 94 Monday, September 14, 2009 12:57 PM