Storage System Hardware Owner's Manual

54 Using the System Setup Program
Password Status Setting the Setup Password option to Enabled prevents the
system password from being changed or disabled at system
start-up.
To lock the system password, assign a setup password in the
Setup Password option and then change the Password Status
option to Locked. In this state, you cannot change the system
password using the System Password option and cannot be
disabled at system start-up by pressing <Ctrl><Enter>.
To unlock the system password, enter the setup password in the
Setup Password field and then change the Password Status
option to Unlocked. In this state, you can disable the system
password at system start-up by pressing <Ctrl><Enter> and
then change the password using the System Password option.
TPM Security
(Off default)
Sets the reporting of the Trusted Platform Module (TPM) in
the system.
When set to Off (default), presence of the TPM is not reported
to the operating system.
When set to On with Pre-boot Measurements, the system
reports the TPM to the operating system and stores the pre-boot
measurements (compliant with Trusted Computing Group
standards) to the TPM during POST.
When set to On without Pre-boot Measurements, the system
reports the TPM to the operating system and bypasses pre-boot
measurements.
TPM Activation Changes the operational state of the TPM.
When set to Activate, the TPM is enabled and activated at
default settings.
When set to Deactivate, the TPM is disabled and deactivated.
The No Change state initiates no action. The operational state
of the TPM remains unchanged (all user settings for the TPM
are preserved).
NOTE: This field is read-only when TPM Security is set to Off.
Table 2-7. System Security Screen Options (continued)
Option Description
Book.book Page 54 Monday, September 14, 2009 12:57 PM