Storage System Hardware Owner's Manual
Table Of Contents
- Hardware Owner’s Manual
- About Your System
- Using the System Setup Program
- Installing System Components
- Recommended Tools
- Inside the System
- Front Bezel
- Opening and Closing the System
- Hard Drives
- Replacing a Hard-Drive Carrier
- Power Supplies
- System Fans
- Cooling Shroud
- Fan Brackets
- Cable Routing
- SAS Controller Daughter Card
- Configuring the Boot Device
- Expansion Cards
- Expansion-Card Cage
- DRAC Card and Cables
- Optical Drive and Cable
- System Memory
- Activating the Integrated NIC TOE
- Processors
- System Battery
- Expansion-Card Riser Boards
- Sideplane Board
- SAS Backplane Board
- Control Panel Assembly (Service-only Procedure)
- System Board (Service-only Procedure)
- Troubleshooting Your System
- Safety First-For You and Your System
- Start-Up Routine
- Checking the Equipment
- Troubleshooting Basic I/O Functions
- Troubleshooting a NIC
- Troubleshooting a Wet System
- Troubleshooting a Damaged System
- Troubleshooting the System Battery
- Troubleshooting Power Supplies
- Troubleshooting System Cooling Problems
- Troubleshooting System Memory
- Troubleshooting an Optical Drive
- Troubleshooting an External SCSI Tape Drive
- Troubleshooting a Hard Drive
- Troubleshooting a SAS Controller Daughter Card
- Troubleshooting Expansion Cards
- Troubleshooting the Microprocessors
- Running the System Diagnostics
- Jumpers and Connectors
- Getting Help
- Glossary
- Index

28 About Your System
E2011 Mem Config
Err
Memory detected, but is
not configurable. Error
detected during memory
configuration.
See "Troubleshooting
System Memory" on
page 142.
E2012 Unusable
Memory
Memory is configured, but
not usable. Memory
subsystem failure.
See "Troubleshooting
System Memory" on
page 142.
E2013 Shadow BIOS
Fail
The system BIOS failed to
copy its flash image into
memory.
See "Troubleshooting
System Memory" on
page 142.
E2014 CMOS Fail CMOS failure. CMOS
RAM not functioning
properly.
See "Getting Help" on
page 167.
E2015 DMA
Controller
DMA controller failure. See "Getting Help" on
page 167.
E2016 Int
Controller
Interrupt controller failure. See "Getting Help" on
page 167.
E2017 Timer Fail Timer refresh failure. See "Getting Help" on
page 167.
E2018 Prog Timer Programmable interval
timer error.
See "Getting Help" on
page 167.
E2019 Parity Error Parity error. See "Getting Help" on
page 167.
E201A SIO Err SIO failure. See "Getting Help" on
page 167.
E201B Kybd
Controller
Keyboard controller
failure.
See "Getting Help" on
page 167.
E201C SMI Init System management
interrupt (SMI)
initialization failure.
See "Getting Help" on
page 167.
E201D Shutdown Test BIOS shutdown test
failure.
See "Getting Help" on
page 167.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions
Book.book Page 28 Monday, September 14, 2009 12:57 PM










