Reference Guide

1-4 Rack Installation Guide

Store the two doors in an area where they will not fall over while you install the
switch.
!()*
If you are installing the switch in a non-Dell rack, you may need to adjust the bezel
position to allow the rack doors to close properly. To adjust the bezel position, perform
the following steps (see Figure 1-4):
1. Remove the two 6-32 x 1/2-inch flathead screws and the mounting clip from one
side of the bezel.
2. Adjust the bezel tab so that the front holes are aligned with the mounting holes
on the manifold.
3. Replace the mounting clip and screws.
4. Repeat steps 1 through 3 on the other side of the bezel.
hinge
release
lever
4939tbk1.book Page 4 Friday, October 8, 1999 1:22 PM