Users Guide

support.dell.com Error Messages A-17
DIAG-INTNOTCLR
(T!"
[centralMemoryTest]
The interrupt bit could not be
cleared
ASIC failure Replace main-
board assembly
DIAG-LCMEM
(T!7
[centralMemoryTest, cmemRe-
tentionTest]
Data read from the Central
Memory location did not match
data previously written into the
same location
ASIC failure Replace main-
board assembly
DIAG-LCMEMTX
(T)!75!
[centralMemoryTest]
Central Memory transmit path
failure: ASIC 1 failed to read
ASIC 2 via the transmit path
Mainboard failure Replace main-
board assembly
DIAG-LCMRS
(T)!5!
[centralMemoryTest, cmemRe-
tentionTest]
Central Memory Read Short: M
bytes requested but got less
than M bytes
ASIC failure Replace main-
board assembly
DIAG-LCMTO
(T)!5!
[centralMemoryTest, cmemRe-
tentionTest]
Central Memory Timeout: Data
transfer initiated did not com-
plete within the timeout period
ASIC failure Replace main-
board assembly
DIAG-MEMNULL
(T!
[ramTest]
Test failed to malloc Mainboard failure Replace main-
board assembly
DIAG-MEMSZ
(T
[ramTest]
Memory size to be tested is
less than or equal to zero
Mainboard failure Replace main-
board assembly
DIAG-MEMORY
(T
[ramTest]
Data read from RAM location
did not match previously writ-
ten data into same location
CPU RAM failure Replace main-
board assembly or
DRAM module
DIAG-PORTABSENT
(T!75-75- 7
[portLoopbackTest, crossPort-
Test, spinSilk]
Port is not present ASIC or mainboard
frame
Replace main-
board assembly
DIAG-PORTDIED
(T!)5-)5- )
[portLoopbackTest, crossPort-
Test, spinSilk]
Port was in loopback mode and
then went inactive
ASIC, GBIC mod-
ule or fiber cable
failure
Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-PORTSTOPPED
(T- 7
[spinSilk]
Port is no longer transmitting
as indicated by the Number of
Frames Transmitted counter
being stuck at N frames
ASIC, GBIC mod-
ule or fiber cable
failure
Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-PORTWRONG
(T-7
[crossPortTest]
Frame erroneously received by
port M instead of the intended
port N
ASIC failure Replace main-
board assembly
02+&
  & )