Users Guide

Table 18. Firewall parameters (continued)
Parameter # Parameter data
● [1:16]—Starting IP address from
which IPs are blocked or unblocked
based on the state.
● [17.32]—Ending IP address until IPs
are blocked or unblocked based on
the state.
Remove the IPv6 address rule 31 Data 1:16—IPv6 address
● MS-byte first. This is an IPv6 address
that is blocked or unblocked based
on state.
Remove the IPv6 address range rule 32 Data 1:16—IPv6 address range
● [1:16]—Starting IP address from
which IPs are blocked or unblocked
based on the state.
● [17.32]—Ending IP address until IPs
are blocked or unblocked based on
the state.
Add the IPv6 port number rule 33 Data 1—Protocol TCP and UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:3—port number
● [2:3]—Port number from the ports
blocked or unblocked based on the
state.
Add the IPv6 port number range rule 34 Data 1—Protocol TCP and UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:5—port number
● [2:3]—Port number from the ports
blocked or unblocked based on the
state.
● [4:5]—Port number till the ports are
blocked or u nblocked based on the
state.
Remove the IPv6 port number rule 35 Data 1—Protocol TCP and UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:3—port number
● [2:3]—Port number from the ports
blocked or unblocked based on the
state.
Remove the IPv6 port number range rule 36 Data 1—Protocol TCP and UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:5—port number
● [2:3]—Port number from the ports
blocked or unblocked based on the
state.
58 Configuration methods