Users Guide

Table 18. Firewall parameters (continued)
Parameter # Parameter data
● Bit 1—IPv6
● Bit 0—IPv4
Remove drop all rule 10 Remove iptables rules to block IPv4
and IPv6 traffic to the BMC. The state
selector is not used.
● Data1: Protocol
● Bit 7:2—Reserved
● Bit 1—IPv6
● Bit 0—IPv4
Add IPv4 address with timeout rule 11 Data 1:4—IP address
● MS-byte first. The IPv4 address type
blocked or unblocked based on the
state.
● Date 5:10—Start time
● [5:6]—Year
● LS-byte first if little endian system.
Two-byte data required to form year.
● 7—month
● 8—date
● 9—hour
● 10—minute
● Date 11-16—stop time
● [11:12]—Year
● LS-byte first if little endian system.
Two-byte data required to form year.
● 13—month
● 14—date
● 15—hour
● 16—minute
Add IPv4 range of addresses with
timeout rule
12 Data 1:8—IP address
● [1:4]—Starting IP address blocked or
unblocked based on the state.
● [5:8]—Ending IP address till IPs are
blocked or unblocked based on the
state.
● Date 9:14—Start time
● [9:10]—Year
● LS-byte first if little endian system.
Two-byte data required to form year.
●
11—month
● 12—date
● 13—hour
● 14—minute
● Date 15-20—Stop time
● [15:16]—Year
● LS-byte first if little endian system.
Two-byte data required to form year.
Add the IPv4 port number with timeout
rule
13 Data 1—Protocol TCP and UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:3—port number
50 Configuration methods