Users Guide

● Request data Byte 1—parameter selector
● Request data Byte 2—State selector
● Request data Byte 3:N—Configuration parameter data
● Response data Byte 1—Completion code
○ 80h—Parameter not supported
○ 81h—Invalid time (start/stop time)
○ 82h—Attempt to write read-only parameter
○ 83h—Attempt to access HTTP Port 80
To set the firewall configuration state, use the following:
Table 17. Firewall set parameters
Type specific param # Parameter data
To set the command to DROP 00 Parameter to drop packets. Parameter
0–3 uses this state to add the rules
to drop the packets based on the IP
address/port number or ange of IP
addresses/port numbers. Use parameter
4–7 to remove the rule.
To set the command to ACCEPT 01 Parameter to accept packets. Parameter
0–3 uses this state to add the rules
to accept the packets based on the
IP address/port number or ange of IP
addresses/port numbers. Use parameter
4–7 to remove the rule.
To set the firewall parameters, use the following:
Table 18. Firewall parameters
Parameter # Parameter data
Add the IPv4 address rule 0 Data 1:4—IP address
● MS-byte first. This is an IPv4 address
that is blocked or unblocked based
on the state.
Add the range of IPv4 addresses rule 1 Data 1:8—IP address range
● [1:4]—Starting IP address from
which IPs are blocked or unblocked
based on the state.
● [5:8]—Ending IP address until IPs are
blocked or unblocked based on the
state.
For example, if the IP address is
x1.x2.x3.x4, the format is:
● 1st byte = x1
● 2nd byte = x2
● 3rd byte = x3
● 4th byte = x4
Add the IPv4 port number rule 2 Data 1:—Protocol TCP/UDP
● 0 = TCP
● 1 = UDP
● 2 = both TCP and UDP
● Data 2:3—port number
● [2:3]—MX byte first. Port number
blocked or unblocked based on the
state.
Add the Pv4 port number range rule 3 Data 1:—Protocol TCP/UDP
48 Configuration methods