Users Guide

User management configuration
Table 12. User management configuration settings
Setting Description
Username Enter the name of the new user:
● For the IPv4 IP address, it consists of four sets of numbers that are separated
by dots, for example, xxx.xxx.xxx.xxx.
● The range is 0–255.
● The first number must not be 0.
Change Password Select this option to change the password.
Password Size Select the size of the password.
Password Enter a strong password that consists of at least one upper case letter,
alphanumeric, and special characters.
NOTE: The password is mandatory if you enable SNMP Access. The password
must have a minimum of eight characters when SNMP status is enabled.
Enable User Access Check the box to enable user access. After enabling the user access, the IPMI
messaging privilege is assigned to the user.
NOTE: Dell Technologies recommends that you enable IPMI messaging for the
user to choose the User Access option, while creating the user through IPMI.
Privilege Select the privilege level that is assigned to this user when the user accesses BMC
through network interface. The network privilege levels are:
● User
● Administrator
● Operator
● None
SNMP Access Check the box to enable SNMP access for the user.
SNMP Authentication Protocol Choose an authentication protocol for the SNMP settings. The password field is
mandatory if you change the authentication protocol.
SNMP Privacy Protocol Choose the Encryption algorithm to use for the SNMP settings.
Email Format Check this option to enable IPv6 DHCP to dynamically configure an IPv6 address
using DHCPv6.
30 BMC web user interface