Users Guide

Table 10. IP address firewall rule settings (continued)
Setting Description
● You must be at least an Operator to view the page. To add or delete a firewall,
user must be an Administrator.
Add IP address rule settings
● IP Single (or) Range Start—Configure the IP address or range of IP addresses.
An IP address supports IPv4 address format only:
○ IPv4 address is four numbers that are separated by dots, for example,
xxx.xxx.xxx.xxx.
○ The range is from 0-255.
○ The first number must not be 0.
● IP Range End—Configured the IP address or range of IP addresses. An IP
address supports IPv4 address format only:
○ IPv4 address is four numbers that are separated by dots, for example,
xxx.xxx.xxx.xxx.
○
The range is from 0-255.
○ The first number must not be 0.
● Enable Timeout—This option enables or disables firewall rules with timeout.
● Start Date—The respective firewall rule effect start from this date.
● Start Time—The respective firewall rule effect start from this time.
● End Date—The respective firewall rule effect ends at this date.
● End Time—The respective firewall rule effect ends at this time.
BMC web user interface 27