Install Guide

LED display
The Z9332F-ON switch includes LED displays on the I/O side of the switch. This section describes open networking installation
environment (ONIE) LED behaviors. Some LED behaviors may change after you install your software.
LED behavior
The following Z9332F-ON switch LED behavior is seen during start up:
NOTE: Although each port has four LEDs, only one LED indicates switch status. The other three LEDs are intentionally
off.
1. Port Activity LEDs 2. Port Activity LEDs
3. System LED 4. Fan LED
5. Power Supply LED 6. Alarm LED
7. RJ45 Ethernet Port LED
NOTE: For an ONIE-installed switch, after ONIE boots, the LED flashes 1 Hz green and yellow.
Table 2. Z9332F-ON switch LED behavior
LED Description
System Status/Health LED
• Solid green—Normal operation
• Flashing green—Booting
• Solid yellow—Major alarm. For example, thermal sensor
reached the critical temperature
• Flashing yellow—Minor alarm. For example, one PSU or fan
failed.
Fan LED
• Off—No fan present
• Solid Green—Normal operation and all fans present
• Solid yellow—Any one fan is absent or any fan status not in a
normal status
Power Supply LED
• Off—No power
• Solid green—Normal operation and all PSUs are present
• Solid yellow—One PSU is absent or any one PSU status is not
in a normal status.
The Z9332F-ON switch 9