Install Guide

Management ports

The Z9332F-ON switch provides three ports for management and one USB flash drive mount for file transfers.

NOTE: The output examples in this section are for reference only. Your output may vary.

Topics:

• RJ45 console port access

• USB storage mount

RJ45 console port access

The management ports are on the I/O-side of the switch.

1. RJ45 console port (top); USB Type-A port (middle); RJ45 Ethernet port (bottom).

NOTE:

Ensure that any equipment that is attached to the serial port can support the required 115200 baud rate.

NOTE: If the serial port on your computer cannot accept a female DB-9 connector, use a DB-9 to USB adapter.

1. Install the provided RJ45 connector-side of the provided cable into the switch console port.

2. Install the DB-9 female-side of the provided copper cable into the serial port on your computer.

Or install the DB-9 cable into other data terminal equipment (DTE) server hardware.

3. Use the following settings to make the serial port connection:

• 115200 baud rate

• No parity

• Eight data bits

• One stop bit

• No flow control

USB storage mount

USB storage does not automatically mount. USB storage supports the FAT file system. To use USB storage, first mount the device using

the following steps:

1. Start up the switch.

2. Press Enter on the ONIE rescue mode menu option from the ONIE Grub boot loader.

3. Create a mount directory for the USB storage.

ONIE:/ # mkdir /mnt/usb

4. View the fixed disks using the fdisk command.

ONIE:/mnt # fdisk -l

Management ports 27