Users Guide

Figure 74. Conguring LLDP
Viewing the LLDP Conguration
To view the LLDP conguration, use the following command.
• Display the LLDP conguration.
CONFIGURATION or INTERFACE mode
show config
Examples of Viewing LLDP Congurations
The following example shows viewing an LLDP global conguration.
Dell(conf)#protocol lldp
Dell(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
Dell(conf-lldp)#
Dell(conf-lldp)#exit
Dell(conf)#interface tengigabitethernet 1/31/1
Dell(conf-if-te-1/31/1)#show config
!
interface TenGigabitEthernet 1/31/1
no ip address
switchport
no shutdown
Dell(conf-if-te-1/31/1)#protocol lldp
Dell(conf-if-te-1/31/1-lldp)#show config
!
protocol lldp
Dell(conf-if-te-1/31/1-lldp)#
Viewing Information Advertised by Adjacent LLDP
Agents
To view brief information about adjacent devices or to view all the information that neighbors are advertising, use the following commands.
• Display brief information about adjacent devices.
480
Link Layer Discovery Protocol (LLDP)