Users Guide

Command Output
To clear PFC TLV counters, use the clear pfc counters
interface port-type slot/port command.
show interface port-type pfc statistics
Displays counters for the PFC frames received and transmitted (by
dot1p priority class) on an interface.
You can use the show interface pfc statistics
command even without enabling DCB on the system.
show interface
port-type ets {summary | detail}
Displays the ETS conguration applied to egress trac on an
interface, including priority groups with priorities and bandwidth
allocation.
To clear ETS TLV counters, enter the clear ets counters
interface port-type slot/port command.
show interface port-type DCBx detail
Plays the DCBx conguration on an interface.
show
Displays the PFC conguration applied to ingress trac, including
priorities and link delay.
Displays the ETS conguration applied to ingress trac, including
priorities and link delay.
Examples of the show Commands
The following example shows the show dot1p-queue mapping command.
Dell(conf)# show qos dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 1 0 2 3 4 5 6 7
The following example shows the output of the show qos dcb-map test command.
Dell#show qos dcb-map test
-----------------------
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3 4
The following example shows the show interfaces pfc summary command.
Dell# show interfaces tengigabitethernet 1/1/4 pfc summary
Interface TenGigabitEthernet 1/1/4
Admin mode is on
Admin is enabled
Remote is enabled, Priority list is 4
Remote Willing Status is enabled
Local is enabled
Oper status is Recommended
PFC DCBx Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 45556 pause quantams
Application Priority TLV Parameters :
--------------------------------------
FCOE TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Remote FCOE PriorityMap is 0x8
Data Center Bridging (DCB)
249