Setup Guide

Figure 3. Two-Post Center-Mount Configuration
Four-Post Threaded Configuration
To install the Dell ReadyRails system using the four-post threaded configuration, follow these steps.
1. For this configuration, remove the flange ear castings from each end of the ReadyRails assemblies.
To remove the two screws from each flange ear and remove each casting, use a Torx driver. See
item 1 of the following figure. Retain the castings for future rack requirements.
2. For each rail, attach the front and back flanges to the post flanges with two user-supplied screws at
each end. See item 2 of the following figure.
8
Install the Hardware