Setup Guide

CONFIGURATION mode

hostname name

Accessing the System Remotely

You can configure the Z9100–ON system to be accessed remotely by Telnet.

The system has a dedicated management port and a management routing table that is separate from the

IP routing table.

1. Configure an IP address for the management port (XXXConfiguring the Management Port IP

Address).

2. Configure a management route with a default gateway (XXXConfiguring the Management Route).

3. Configure a username and password (XXXConfiguring the Username and Password).

Configuring the Management Port IP Address

In order to access the system remotely, assign IP addresses to the management ports.

1. Enter INTERFACE mode for the Management port.

CONFIGURATION mode

interface ManagementEthernet slot/port

2. Assign an IP address to the interface.

INTERFACE mode

ip address ip-address/mask

3. Enable the interface.

INTERFACE mode

no shutdown

Configuring the Management Route

Define a path from the Z9100–ON to the network from which you are accessing the Z9100–ON

remotely.

Management routes are separate from IP routes and are used to manage the Z9100–ON through the

management port.

• Configure a management route to the network from which you are accessing the system.

CONFIGURATION mode

management route ip-address/mask gateway

Configuring the Username and Password

To access the system remotely, configure a system username and password.

• Configure a username and password to access the system remotely.

CONFIGURATION mode

username username password [encryption-type]

Dell Networking OS