Setup Guide

Figure 10. DC Power Connector and Wiring Block

1. Screws

2. Wiring Block

3. Power Connector

To connect a DC PSU to the site’s DC power source, follow these steps:

1. Strip 1/2 inches of insulation from each of the power connector’s wires (red and black), as shown.

2. Insert each of the power connector’s bare wire lengths into the wiring block. Insert red into one hole

and black into the other hole, as shown.

3. Use a flat-blade screwdriver to tighten the screws that secures the bare wires into the wiring block.

4. Secure the site’s DC power source wires to the other side of the wiring block (See steps 1 and 3).

WARNING: Do not cross the wires — In the wiring block, red aligns with red and black aligns

with black.

5. Insert the DC power connector into the power socket of the DC PSU. Ensure that the connector pins

firmly seat and you hear the click of the power connector’s left and right levered clamps lock into

place.

WARNING: Never try to force the power connector into or out of the DC PSU power socket.

Install the Hardware