Install Guide

• 1 stop bit

• No ow control

MicroUSB-B console port access

The MicroUSB type B console port is on the I/O side of the switch.

NOTE: The Z9100-ON switch uses the Silicon Labs CP2102 USB-B chip. To nd the correct USB-B universal asynchronous

receiver-transmitter (UART) driver, see https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-

drivers.

The terminal settings are the same for the serial console port and the RS-232/RJ-45 console port:

• 115200 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No ow control

When you connect the MicroUSB-B port, it becomes the primary connection and, while connected, all messages are sent to the

microUSB-B port.

NOTE: Before starting this procedure, be sure that you have a terminal emulation program already installed on your PC. Install

the appropriate drivers to support the microUSB-B port. For assistance or to download the drivers, contact www.dell.com/

support. If your computer requires non-Dell EMC drivers, contact Dell EMC Technical Support for assistance.

1 Power on the PC.

2 Connect the USB-A end of cable into an available USB port on the PC.

3 Connect the microUSB-B end of cable into the microUSB-B console port on the Z9100-ON.

4 Power on the switch.

5 Install the necessary USB device drivers.

To download the drivers, go to www.dell.com/support. For assistance, contact Dell EMC Technical Support.

6 Open your terminal software emulation program to access the Z9100-ON.

7 Conrm that the terminal settings on your terminal software emulation program are as follows:

• 115200 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No ow control

USB storage

USB storage supports the FAT le system. USB storage does not automatically mount, to use USB storage, rst mount the device.

1 Create a mount directory for the USB storage.

ONIE:/ # mkdir /mnt/usb

2 View the xed disks using the fdisk command.

ONIE:/mnt # fdisk -l

For internal storage:

Disk /dev/sda: 15.8 GB, 15829303296 bytes

255 heads, 63 sectors/track, 1924 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

Management ports