CLI Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
all Enter the keyword all to display information on all
interfaces.
events Enter the keyword events to display major events such as
timer events.
packet Enter the keyword packet to display information regarding
packets coming in or going out.
brief Enter the keyword brief to display brief packet
information.
detail Enter the keyword detail to display detailed packet
information.
tx Enter the keyword tx to display transmit-only packet
information.
rx Enter the keyword rx to display receive-only packet
information.
both Enter the keyword both to display both receive and transmit
packet information.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Link Layer Discovery Protocol (LLDP)
985