CLI Guide

Version Description

6.1.1.0 Introduced on the E-Series.

Usage Information The following commands are not supported by the do command:

• enable

• disable

• exit

• config

Example

Dell(conf-if-te-1/1/1)# do clear counters

Clear counters on all interfaces [confirm]

Dell(conf-if-te-1/1/1)#

Dell(conf-if-te-1/1/1)# do clear logging

Clear logging buffer [confirm]

Dell(conf-if-te-1/1/1)#

Dell(conf-if-te-1/1/1)# do reload

System configuration has been modified. Save? [yes/no]: n

Proceed with reload [confirm yes/no]: n

enable

Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may

need to enter a password.

Syntax

enable [level]

Parameters

level (OPTIONAL) Enter a number for a privilege level of Dell

Networking OS. The range is from 0 to 15.

Defaults 15

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.0) Added support for roles on the Z9000, S6000, S4820T,

S4810, and MXL.

9.2(1.0) Introduced on the Z9500.

Control and Monitoring