CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Updated the output.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show mac-address-table command shown in the
following example.
Column
Heading
Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned dynamically (Dynamic), or associated with a
specific port (Sticky).
Interface Displays the interface type and slot/port[/subport]
information. The following abbreviations describe the
interface types:
• Po = port channel
• Te = ten-gigabit Ethernet
• Fo = forty-gigabit Ethernet
• Tf = twentyfive-gigabit Ethernet
• Fi = fifty-gigabit Ethernet
• Hu = hundred-gigabit Ethernet
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
Example
Dell(conf)# do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac
Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po
128 Active
2 00:00:00:00:00:02 Dynamic (N) Po
10 Active
Layer 2
953