CLI Guide

Version Description

8.2.1.0 Introduced on the S-Series.

7.8.1.0 Introduced on the C-Series.

Usage Information

For the new settings to take effect, save the new CAM settings to the startup-

config (write-mem or copy run start) then reload the system.

The total amount of space allowed is 16 FP Blocks. System flow requires three

blocks and these blocks cannot be reallocated. The ipv4acl profile range is from

1 to 4.

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which

is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

If you enabled BMP, to perform a reload on the chassis to upgrade any

configuration changes that have changed the NVRAM content, use the reload

conditional nvram-cfg-change command.

clear line

Reset a terminal line.

Syntax

clear line {line-number | console 0 | vty number}

Parameters

line-number Enter a number for one of the 12 terminal lines on the

system. The range is from 0 to 11.

console 0 Enter the keywords console 0 to reset the console port.

vty number Enter the keyword vty then a number to clear a terminal

line. The range is from 0 to 9.

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

Control and Monitoring