CLI Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Use this command to confirm that the neighbor adjacencies are operating
correctly. If you suspect that they are not, you can verify the specified area
addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the
following example.
Field Description
System Id The value that identifies a system in an area.
Interface The interface, slot, and port in which the router was
discovered.
Intermediate System to Intermediate System (IS-IS)
927