CLI Guide

Override the default restart-wait time by entering the no graceful-restart

restart-wait command. When you disable restart-wait, the current

adjacency hold time is used.

Set the t3 timer to adjacency on the restarting router when implementing this

command. The restarting router gets the remaining time value from its peer and

adjusts its T3 value so only when you have configured graceful-restart t3

adjacency

Commands

• graceful-restart restart-wait — enable the graceful restart maximum wait time

before a restarting peer comes up.

hello padding

Use to turn ON or OFF padding for LAN and point-to-point hello PDUs or to selectively turn padding ON

or OFF for LAN or point-to-point hello PDUs.

Syntax

hello padding [multi-point | point-to-point]

To return to the default, use the no hello padding [multi-point | point-

to-point] command.

Parameters

multi-point (OPTIONAL) Enter the keywords multi-point to pad only

LAN hello PDUs.

point-to-point (OPTIONAL) Enter the keywords point-to-point to pad

only point-to-point PDUs.

Defaults Both LAN and point-to-point hello PDUs are padded.

Command Modes ROUTER ISIS

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

884

Intermediate System to Intermediate System (IS-IS)