CLI Guide

Version Description
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
debug isis local-updates
To debug IS-IS local update packets, enable debugging on a specific interface and provides diagnostic
information.
Syntax
debug isis [vrf vrf-name] local-updates [interface]
To turn off debugging, use the no debug isis [vrf vrf—name] updates
[interface] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable the debugging information on IS-IS
corresponding to that VRF. This information contains local
updates tied to the VRF that you specify. This command
displays the local LSP debugging details of the current unit.
interface (OPTIONAL) Identifies the interface type as one of the
following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes EXEC Privilege
866
Intermediate System to Intermediate System (IS-IS)