CLI Guide

Example
Dell# configure
Dell(conf)# cam-acl-egress ?
default Reset Egress CAM ACL entries to default setting
l2acl Set L2-ACL entries
Dell(conf)# cam-acl-egress l2acl ?
<1-4> Number of FP blocks for l2acl
Dell(conf)# cam-acl-egress l2acl 1 ?
ipv4acl Set IPV4-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl Set IPV6-ACL entries
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4> Number of FP blocks for IPV6 (multiples of 2)
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
Dell(conf)#
cam-acl
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos
1-10 l2qos 1-10}
Parameters
default Use the default CAM profile settings, and set the CAM as
follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10
l2qos 1-10
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount
to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
856
IPv6 Access Control Lists (IPv6 ACLs)