CLI Guide

bootselector-
image
Enter the keyword bootselector-image to upgrade the
BIOS system image.
stack-unit-id Enter the stack–unit–id to upgrade only the mentioned
stack-unit .
all Enter the keywords all to upgrade the member stack-
units.
booted Enter the keyword booted to upgrade from the current
image on the device.
ftp: Enter the keyword ftp to follow it with the location of the
source file in this form: //userid:password@hostip/filepath,
or press Enter to launch a prompt sequence.
tftp: Enter the keyword tftp to follow it with the location of the
source file in this form: //hostlocation/filepath, or press
Enter to launch a prompt sequence.
flash: Enter the keyword flash to follow it with the location of
the source file in this form: //filepath, or press Enter to
launch a prompt sequence.
usbflash: Enter the keyword flash to follow it with the location of
the source file in this form: //filepath, or press Enter to
launch a prompt sequence.
A: Enter the keyword A to upgrade the bootflash partition A:.
B: Enter the keyword B to upgrade the bootflash partition B:.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
9.0(0.0) Added support for IPv6 for the file-url parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000. Added support for the SSD on the
Z9000 only.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for TFTP and SCP.
File Management
85