CLI Guide

allowed for the system. This command is not applicable to the default and
management VRFs.
show cam-ipv6 extended-prefix
Display the current settings and next-boot settings for cam-ipv6 extended-prefix configuration. Display
the cam-ipv6 extended-prefix configuration.
Syntax
show cam-ipv6 extended-prefix
Defaults None
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage Information You can use this command to view the number of supported extended prefix
entries in LPM configured. The output also displays the current applied value and
the new value that is applicable after the reboot of the device.
Example
Dell# show cam-ipv6 extended-prefix
Cam-Ipv6-LPM Extended Prefix
--------------------------------
Current Settings
cam-ipv6-max-/65-to-/128-Prefix : 2048
Dell(conf)#
ipv6 unicast-host-route
Enable programming of IPv6 /128 route prefixes in L3 host table.
Syntax
[no] ipv6 unicast-host-route
838
IPv6 Basics