CLI Guide

maximum dynamic-routes-ipv6
Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.
Syntax maximum dynamic-routes—ipv6 limit {warn-threshold threshold-value
| warning-only}
To remove the limit on the maximum number of IPv6 routes used, use the no
maximum dynamic-routes-ipv6 command.
Parameters
limit Maximum number of IPv6 routes allowed in a VRF. Valid
range is from 1 to 8000 (or maximum allowable for that
platform if smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of IPv6 routes reaches the
specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional routes will not be
allowed into the RTM ( route table manager ) itself.
warning-only When the warning-only option is used, a syslog message
will be thrown when maximum number of dynamic IPv6
routes reaches the limit. Additional dynamic IPv6 routes will
still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes
CONFIGURATION-VRF
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, and Z9500.
Usage Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to
8000), then it has unlimited space that extends to the maximum number of entries
IPv6 Basics
837