CLI Guide

System Type: Z9100-ON
Control Processor: Intel Rangeley with 3 Gbytes (3177185280
bytes) of memory, core(s) 2.
8G bytes of boot flash memory.
1 34-port TE/TF/FO/FI/HU G (Z9100-ON)
2 Ten GigabitEthernet/IEEE 802.3 interface(s)
32 Hundred GigabitEthernet/IEEE 802.3 interface(s)
Dell#
upgrade system
Upgrade the system image.
Syntax
upgrade system {flash: | ftp: | scp: | tftp: | usbflash: |
stack-unit {stack—unit—id | all} {A: | B:}
Parameters
stack–unit–id Enter the stack–unit–id to upgrade only the mentioned
stack-unit.
all Enter the keyword all to upgrade all the member units of
the stack.
ftp: Enter the keyword ftp to follow it with the location of the
source file in this form: //userid:password@hostip/filepath,
or press Enter to launch a prompt sequence.
scp: Enter the keyword scp to follow it with the location of the
source file in this form: //userid:password@hostip/filepath,
or press Enter to launch a prompt sequence.
tftp: Enter the keyword tftp to follow it with the location of the
source file in this form: //hostlocation/filepath, or press
Enter to launch a prompt sequence.
flash: Enter the keyword flash to follow it with the location of
the source file in this form: //filepath, or press Enter to
launch a prompt sequence.
usbflash: Enter the keyword flash to follow it with the location of
the source file in this form: //filepath, or press Enter to
launch a prompt sequence.
A: Enter the keyword A to upgrade the bootflash partition A:.
B: Enter the keyword B to upgrade the bootflash partition B:.
Defaults none
Command Modes EXEC Privilege
File Management
83