CLI Guide

N2- OSPF NSSA external type 2, E1 - OSPF external type 1,
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate
default,
>- non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 2.1.0.0/24 via 2.1.4.1, Te 1/13/1 120/2 3d0h
R 2.1.1.0/24 via 2.1.4.1, Te 1/13/2 120/2 3d1h
R 2.1.2.0/24 via 2.1.4.1, Te 1/13/3 120/1 3d0h
R 2.1.3.0/24 via 2.1.4.1, Te 1/13/4 120/1 3d1h
C 2.1.4.0/24 Direct, Te 1/14/1 0/0 3d1h
Related
Commands
• ip prefix-list — enter CONFIGURATION-IP PREFIX-LIST mode and configures a
prefix list.
• show ip prefix-list summary — display a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
Syntax
show ip route [vrf vrf-name] [summary]
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view information on the IP routes corresponding to that
VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
IPv4 Routing
827