CLI Guide

Parameters
stack-unit-
number
Enter the stack-unit ID. The unit ID range is from 1 to 6.
port-set pipe-
number
Enter the keyword port-set then the number of the stack unit’s port-
pipe.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to display CAM
entries corresponding to that VRF.
network mask
[longer-prefixes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for
that route only. You can enter one of the following keywords to filter
results.
• Enter the keyword longer-prefixes to view routes with a common
prefix.
• Enter the keyword ecmp-group detail to view the ECMP group
index.
ecmp-group
{detail | member-
info [detail
[group-index
index-number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the following
keywords to filter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member information for
the ECMP group.
• Enter the keyword member-info detail to view detailed ECMP
membership and n-hop information.
• Enter the keyword group-index then the index number to show
ECMP membership per group. The range is from 0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
IPv4 Routing
809