CLI Guide

Usage Information This command disables the incrementing of the hops field when boot requests are
relayed to a DHCP server through Dell Networking OS. If the incoming boot
request already has a non-zero hops field, the message is relayed with the same
value for hops. However, the message is discarded if the hops field exceeds 16, to
comply with the relay agent behavior specified in RFC 1542.
Related
Commands
• ip helper-address — specify the destination broadcast or host address for DHCP
server requests.
• show running-config — display the current configuration and changes from the
default values.
ip host
Assign a name and an IP address to the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
name Enter a text string to associate with one IP address.
ip address Enter an IP address, in dotted decimal format, to be mapped
to the name.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
782
IPv4 Routing