CLI Guide

• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior
limit was 2094).
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Added the access-group option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.3.1.0 Added the count option.
Usage Information The following describes the debug ip packet command in the following
example.
Field Description
s= Lists the source address of the packet and the name of the
interface (in parentheses) that received the packet.
d= Lists the destination address of the packet and the name of
the interface (in parentheses) through which the packet is
being sent out on the network.
len Displays the packet’s length.
sending, rcvd,
fragment, sending
The last part of each line lists the status of the packet.
772
IPv4 Routing