CLI Guide

cp (OPTIONAL) Enter the cp to clear only statistics from the
Control Processor.
rp (OPTIONAL) Enter the keyword rp to clear only the statistics
from Route Processor.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
debug arp
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
766
IPv4 Routing